![]() ![]() If you then select the "B" part, you will notice in its properties that it has the flag set to be cut as a single operation. It is expected that the Job Editor will have both parts in it when the import is complete, but the "B" part will not appear in the cncrun.txt file. When Router-CIM Automation Suite reads them in, it determines that identifying character and sets the job up to cut the "B" part as a separate part from the nested parts. The parts which have DXF names that include an "F" as the fourth character are all entered as two parts automatically by the system, one which has the "F" in the fourth position, and one that has a "B" in the fourth position. Likewise in Router-CIM Automation Suite there is a similar provision to cut them apart from the nested parts. There is a provision in Cabinet Vision to identify the parts which have backside or secondary operations. Typically, dadoes and rabbets should be output as rectangles that overlap the edge of the material by one tool radius (if the cut is to extend to the edge of the part).Īll geometry should be output with negative thickness indicating cut depth. Layer to Knowledge Associations for Cabinet Vision Router-CIMĪll geometry that is to be cut in a like fashion (same tool, spindle, feedrate, etc.) should be placed on the same layer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |